![]() ![]() The ECoS is much more friendly and powerful than DB-150 or any other manufacturer's command station. This is my main way of introducing and modifying DCC for large roster of mixed manufacturer decoders On LocoNet DB-150 as Service Mode on Programming Track. I can't Read type from decoder during Create New Loco and Read All Sheets I would not use the Digitrax throttles in this scenario. With L.Net on the ECoS I could make the DB-150 a booster and when separated be the command station. Moving the assignment would be nice without restart but not easily available currently. ![]() My question is how to assign throttle to a single command station when multiple layout aka command stations are configured in JMRI. On Feb 9, 2021, at 6:49 AM, Lee T Davy wrote: Doing the first one is hard, involves custom electronics, and there’s not a lot of support in JMRI for it. Or trying to have one source of a DCC signal, and _another_ device providing a service-mode programming track? multiple "command stations as NMRA defined", where it’s the command station the generates the DCC signal by definition) Are you trying to have multiple sources of the DCC signal on the layout? (I.e. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
May 2023
Categories |